Publicidad
Idiomas disponibles
Idiomas disponibles
SM 1619X09207 9-14_SPT77WM WML 9/12/14 7:05 AM Page 11
MAXIMUM DEPTH OF CUT STABILITY
ADJUSTMENT
Note; Feature is set during assembly.
Adjustment may be required due to wear and
tear on the tool.
Disconnect plug from power source. Set tool to
zero bevel. Place tool on foot plate onto a level
surface with rear of foot over hanging work
bench by about 2 inches. Loosen the depth
adjustment lever. Set tool to maximum depth
of cut. If the adjustment set screw is in contact
to the motor housing prior to achieving
maximum depth of cut then lower set screw
using a 3/16" Allen wrench until maximum
depth of cut is reached. If set screw is not in
contact with motor housing when maximum
WRENCH USAGE
Wrench provided has several functions other than
loosening/tightening the blade bolt (Fig. 8).
1. Loosening/tightening blade bolt (1/2" wrench)
2. Loosening/tightening combo oil plug/lock
button assembly (1/2" wrench)
3. Loosening/tightening brush caps (slotted driver)
4. Loosening/tightening bevel/depth levers when
levers are over tightened or additional tightening
is needed (9/16" wrench)
5. Blade diamond arbor knock out (wedge
feature)
Storage is provided on the tool (Fig. 1A). Wrench
is fully seated when second lock detent is
engage.
Wrench needs to be inserted
CAUTION
!
with the correct orientation
(Fig. 9). Damage to work piece could occur if
inserted incorrectly.
1/2" WRENCH
9/16" WRENCH
CORRECT
depth of cut is reached then raise the set
screw until it just engages the motor housing
(Fig 7).
FIG. 7
1
3
WEDGE
FEATURE
SLOTTED
DRIVER
FIG. 9
-11-
SET SCREW
FIG. 8
2
INCORRECT
4
5
Publicidad
