Descargar Imprimir esta página

Parkside PBRM 39 C2 Instrucciones De Servicio Y Seguridad página 15

Cortacésped de gasolina

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 70
4. Put down the rear discharge flap (15), it holds the grass
collection basket (16) in position.
12.1.2
Emptying the grass collection basket (16)
(Fig. 11)
WARNING
Before removing the grass collection basket, switch off
the engine and wait for the blade to stop.
ATTENTION
Danger of injury!
Remove the grass collection basket only when the engine is
switched off and the blade is stationary.
The grass collection basket must be emptied as soon as
grass cuttings are left lying behind on the ground during
mowing.
1. To remove the grass collection basket (16), lift the rear
discharge flap (15).
2. Take out the grass collection basket (16) by the carrying
handle. In accordance with the safety regulations, the dis-
charge flap (15) closes when the grass collection basket
(16) is unhooked and closes the rear ejection opening.
If grass cuttings remain in the opening, it is advisable to pull
the lawnmower back about one metre to make it easier to
start the engine.
ATTENTION
Do not remove cuttings in the mower housing and on the
working tool by hand or with your feet, but with suitable
aids, e.g. brush or hand brush.
To ensure good collection, the grass collection basket (16)
and in particular the air filter (9a) must be cleaned from the
inside after use.
12.2
Starting the engine
NOTE
The blade rotates when the engine is started.
Do not start the product if the ejector chute is covered by one
of the following parts:
• Grass collection basket
12.2.1
Starting the engine (Fig. 1 + 12)
1. Check the fuel and engine oil levels before each start (see
sections 10.1 and 10.2). Make sure that the spark plug
connector (12) is connected to the spark plug (12a).
2. In colder temperatures, press the fuel pump "primer" (10)
three times. This makes it easier to start the product.
3. Stand behind the lawnmower. One hand pushes the en-
gine brake lever (2) to the steering (1), the other pulls the
pull starter (18).
4. Start the engine with the pull starter (18). To do this, pull
the handle out approx. 10-15 cm (until resistance is felt).
And then pull hard with a jerk. If the engine does not
start, pull on the pull starter (18) again.
5. Due to protective coating on the engine, a small amount
of smoke may be present during the initial use of the
product and should be considered normal. This is a nor-
mal process.
NOTE
Only use the fuel pump "primer" when the en-
gine is cold!
ATTENTION
Do not allow the pull starter to recoil. This can result in
damage.
In case of cool weather, it may be necessary to repeat
the starting process numerous times.
12.3
Shut off engine
WARNING
Danger of injury!
After switching the engine off, the blade continues to run for
a few seconds. If you touch the rotating parts, you may cut
yourself.
Wait until the blade comes to a standstill.
Do not stop the blade with your hand.
Wear protective gloves.
Keep the blade away from your feet.
1. To switch off the engine, release the engine brake lever
(2). Wait until the blade (19) stops.
2. Disconnect the spark plug connector (12) from the spark
plug (12a) to prevent the engine from restarting.
12.4
After mowing
1. Always allow the engine to cool down before parking the
lawnmower in an enclosed space. Remove grass, leaves,
grease, and oil before storage. Do not store other objects
on the lawnmower.
2. Check all screws and nuts before the next use. Tighten up
loose screws.
3. Empty the grass collection basket (16) before the next
use.
4. Please also observe the chapter " Storage".
13
Cleaning
WARNING
Danger of injury and burning!
The product can start unexpectedly and cause injuries.
Switch off the motor before carrying out any cleaning or
maintenance work.
Allow the motor to cool down.
Disconnect the spark plug connector from the spark
plug.
WARNING
Health hazard!
Inhalation of fuel / lubricating oil vapours and exhaust gas-
es can cause serious damage to health, unconsciousness
and in extreme cases death.
Do not breathe fuel / lubricating oil vapours and ex-
haust gases.
Operate the product outdoors only.
GB / IE / NI / CY / MT
|
9

Publicidad

loading