QJMOTOR SRT 700 Manual Del Usuario página 44

Headlamp beam adjustment
The headlight beam can
be adjusted vertically up
a n d d o w n . T h e h i g h
beam height adjustment
screw 1 and the low
beam height adjustment
screw 2 are located on
the left side of the headlamp. Rotate the beam
height adjustment screw clockwise or counterclock-
wise to adjust the beam down or up.
Notice
When adjusting the beam height, the driver should
sit on the vehicle seat cushion and keep the vehi-
cle upright for adjustment.
Replacement of the light source
When replacing a broken bulb, be sure to use a bulb
with the same wattage rating. Using bulbs with dif-
ferent wattage ratings may cause overloading of the
electrical system and premature failure of the bulb.
The light source of the vehicle lighting and light sig-
nal device adopts LED, and the LED light source is
not easy to be damaged. If you need to replace it,
please contact the dealer to replace the whole lamp.
ABS use and maintenance instructions
When the power lock is turned on, the ABS indicator
light on the instrument panel will be on (not flash-
ing), which is normal. After the riding speed reaches
5km/h, the ABS indicator light on the instrument
panel will be off, and the ABS is in normal working
condition.
The ABS light is on (not flashing), indicating that the
ABS is in a diagnostic state.
If the ABS light goes out, it means that the ABS is in
normal working condition.
The flashing ABS light indicates that the ABS is not
working (or malfunctioning).
If the ABS indicator light keeps flashing, it means
the ABS is not working. Please check whether the
ABS insert is in place, and whether the clearance
between the ABS wheel speed sensor and the ring
gear is within the range of 0.5-1.5mm.
If the ABS wheel speed sensor is damaged, the
ABS indicator light on the instrument panel will flash
and the ABS will not work. Because the ABS wheel
speed sensor has certain magnetism, it may attract
39