!
LED auto/man function LED OFF: Automatic alignment
– The device automatically levels itself within a range of ± 4°. During the
set-up phase, the laser rotates and the tilt LED flashes. When leveling is
complete, the tilt LED flashes quickly. The laser rotates at maximum speed.
See also the section on "Sensor Automatic" and "ADS-Tilt".
If the device has been placed on a surface with a slope of more than
!
4°, the prism head will remain stationary and the laser as well as the
auto/man LED will start to flash. The device must then be placed on a
more even surface.
Positioning the vertical laser level
In vertical mode the laser level can be positioned exactly. "Sensor Automatic"
remains active and levels to the vertical laser level. Refer to the illustration below.
!
If the auto/man LED flashes, the maximum adjustment range of 4° has
been reached. Set up the device horizontally, turn it off and then on again.
22
EN
auto
X