Keysight U1241B Guía Del Usuario Y Servicios página 41

Data Hold (Trigger Hold)
The data hold function allows users to freeze the displayed digital value.
1 Press
2 Press
3 Press
Refresh Hold
Users are required to activate the Refresh Hold in the setup mode.
1 Press
2 The multimeter is ready to hold new measuring value once the variation of
3 The hold value will be updated until the measuring value is stable. The
4 Press
– For voltage, current and capacitance measurements, the holding value will
NOTE
– For resistance and diode measurements, the holding value will not be
– The holding value may not be updated if the reading does not reach stable
Keysight U1241B and U1242B User's and Service Guide
to freeze the displayed value and to enter manual trigger mode.
Notice the annunciator is displayed.
to trigger the freeze of the next value being measured. The
annunciator will flash before the new value is updated onto the
display.
for more than one second to exit this mode.
to enter Refresh Hold mode. The present value will be held, and
the annunciator is displayed.
measuring value exceeds the setting of variation count, and the
annunciator is flashed.
annunciator will stop flashing and stays lit, an audible tone will sound to
remind user.
again to disable this function.
not be updated if the reading is below 50 counts.
updated if the reading is in "OL" (open state).
state for all measurements.
Features and Functions 2
41