Keysight U1241B Guía Del Usuario Y Servicios página 51

Table 3-1 Available setting options in Setup mode
Menu item
Setup Description
rHd Trigger hold
SCA Percentage scale
FrE Minimum frequency
can be measured
bEP Frequency of beep
sound
Thermocouple
tnP
Log Data logging
(for U1242B)
APF
Auto power off
Lit Backlight timer
dAC Default AC or DC for
voltage and current
measurements
Keysight U1241B and U1242B User's and Service Guide
Selection
OFF
100–1000
0–20 mA,
4–20 mA
0.5 Hz, 1 Hz,
2 Hz, 5 Hz
3746 Hz
2400 Hz,
1200 Hz,
600 Hz, 300 Hz
OFF
tYPE
[a]
tYPE
tYPE mV
Hand
1–9999
1–99 m
[a]
OFF
1–99
OFF
dC, AC
Available setting options
Description
Enables Data Hold (manual trigger)
Sets variation count that determines Refresh Hold
(auto trigger)
Sets % scale readout for 0 to 20 mA or 4 to 20 mA 4–20 mA
Sets the minimum frequency that can be
measured in AC measurement mode
Sets frequency of beep sound of the multimeter
Disables beep sound of multimeter
Sets thermocouple type to K-type
Sets thermocouple type to J-type (for U1242B)
Sets 100 mV measurement for T1 input
Enables manual data logging
Sets interval for automatic data logging from 1 to
9999 seconds. Press
the digit to be adjusted.
Sets timer in minutes for auto power off
Disables auto power off
Sets timer in seconds for auto turn-off for
backlight display
Disables auto turn-off for backlight display
Defines the preferred setup of AC or DC for
voltage and current measurement once
multimeter is turned on.
Default Setting Configurations
Defaul t factory
setting
500
0.5 Hz
3746 Hz
Hand
to toggle through
15 m
15
dC
(For firmware version
2.13 and below)
AC
(For firmware version
2.14 and above)
3
tYPE K
[b]
[b]
51