Keysight U1241B Guía Del Usuario Y Servicios página 75

6 Set the code, same as the last 4 digit serial number of the multimeter. Press
7 If the 4 digit serial number entered is correct, the secondary display will show
Using the Front Panel for Adjustments
This section describes the process used to perform adjustments from the front
panel.
Selecting the Adjustment Mode
Unsecure the multimeter, see
Unsecuring the Multimeter Without the Security
been unsecured, the reference value will be indicated on the primary display.
Entering Adjustment Values
1 Press
2 Press
3 Apply the respective corresponding input signal from the recommended test
4 Press
Ensure that the accuracy of the input signal adheres to the
NOTE
Input Values
Keysight U1241B and U1242B User's and Service Guide
(Save) to confirm the entry.
PAS. If an invalid code is entered, the multimeter will show error code E03.
Ensure that the last 4 digit serial number is entered correctly and repeat the
step 1 to 7.
and
display.
and
from digits 0 through 9.
equipment in Table 5-1.
(Save) when done to start calibration.
in Table 5-3.
Performance Tests and Calibration
Unsecuring the Multimeter for Calibration
to step through each character in the primary
to change the value of the corresponding character
Code. Once the multimeter has
Valid Adjustment
5
or
75