Adjusting The Boundary Range: Warning Area And Stimulation Area - Num'axes Canifugue Mix Manual De Instrucciones

• Activate/deactivate the transmitter
• Activate: connect the transmitter to the power supply by plugging the AC adapter into the power jack on the transmitter
and into a wall outlet. Indications appear on the LCD screen, the transmitter is On.
• Deactivate: disconnect the AC adapter from the wall outlet. The LCD screen goes out, the transmitter is Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the antenna socket. The wire
break alarm would alert you to a connexion default (ref. § Safety features).
When you disconnect the transmitter, the boundary settings are memorized. Next time you will activate the transmitter, the
settings will be the last selected.
• Activate/deactivate the CANIFUGUE MIX receiver collar
• Activate:
as soon as the battery is in place, the collar is ready for use.
To fit the battery in the collar, proceed in the following way:
− Unscrew the 4 screws of the battery cover using a screwdriver.
− Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery housing (ref. Diagram 3).
− A beep sound is emitted indicating the collar is ready for use. If you do not hear any beep sound after having inserted the
battery, remove it immediately from its housing. Check the polarity before trying again.
− Before putting the lid back in place, check that the rubber seal is in its groove.
− Retighten moderately the 4 screws.
• Deactivate:
if you wish to turn the collar Off, you should remove the battery from its housing.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
If your dog needs to leave the authorized area, you have to remove the collar or deactivate the transmitter by disconnecting
it from the power supply.
•

Adjusting the boundary range: warning area and stimulation area

Adjustment buttons on the transmitter enable you to increase or decrease the width of the warning and stimulation zones
depending on the configuration of your yard and how the wire is laid.
First of all, select on the transmitter the position of the small/large ground selector according to your ground:
27