Installing The Drivers - Bresser 88-54200 Instrucciones De Uso

These are the parts of your
microscope
1. Optical Zooming switch
2. Power LED
3. POWER & ZOOM IN
& MENU button
4. LCD monitor
5. FUNCTION (Right) button
6. PLAYBACK (left) button
7. USB Port
8. SD Card Socket
9. Strap Eyelet
10. SHUTTER/OK button
11. TV OUT (optional) port
12. View case (optional)
13. Battery Compartment Cover
14. Lens
15. Tripod /Screw Socket
16. LED lights
17. Magnifi cation Revolving Switch
18. Neck strap
19. Wrist strap
20. Video Cable (optional)
21. Software CD and USB Cable
20
1. Install Batteries
1. Rotate the screw. Take off the
View case.
2. Slide and open the battery com-
partment cover.
3. Put in the batteries in the correct
direction. + and - terminals has
shown..
4. Slide and close the battery com-
partment cover.
2. Driver and Software Installation

2.1 Installing the Drivers

Attention!
Do not connect the „USB Hand
Microscope LCD" to your PC
(computer) yet. In order to work with
the „USB Hand Microscope LCD"
for the long term, we recommend
that you always connect it to the
same USB port. In some cases, your
computer may not detect the device.
If this occurs, you can typically fi x
the issue by re-installing the drivers
(from the CD). If this does not work,
please see the chapter on trouble-
shooting.
Insert the supplied CD-ROM into
your CD/DVD drive. The CD menu
opens automatically. If the menu
does not open, select the CD/DVD
drive in Windows Explorer. There,
start the fi le „Menu.exe" with a
double click.
Please make sure that the „USB
Hand Microscope LCD" is not con-
nected to your PC.
Take the following steps:
1. Save the current data and close
any open programs.
2. Click on „Treiber Installieren".
3. The „Setup Status" window now
appears. The program fi les are
copied to your PC. This process can
take a few minutes.
4. After the window disappears,
it can take a few moments before
the „InstallShield Wizard Complete"