BQS BYF 123 Manual De Uso página 10

installing the Top Tether
1. Take the Top Tether. Lengthen the strap if necessary by
pressing the Top Tether brake button
2. Attach the Top Tether hook to the Top Tether anchorage point
which is recommended in the owner's manual for your car (fig.
3.6).
Look for this symbol
in your vehicle.
3. To tighten the Top Tether, remove any slack by pulling on the
free end of the strap until it is suitably tightened. The Top
Tether will be properly tightened when the tension indicator
turns completely green (fig. 3.7).
4. FastenInG tHe cHIld Into tHe seat Group 1.
1. Loosen the harness straps by stretching the chest section while
holding down the harness adjustment button
2. Open the buckle (fig. 4.1 and 4.2)
3. Place the child into the seat.
4. Fit the safety harness around the child and connect the 2 parts
of the fastener, inserting them into the buckle until you hear a
click (fig. 4.3) which indicates that it is securely locked.
5. Stretch the harness adjustment belt
harness the correct amount of tension. Remember that
harnesses must be well-tightened in order to guarantee the
child's safety (4.4).
5. adjustInG tHe HeIGHt oF tHe Headrest
The correct adjustment of the headrest ensures that the child
is properly fastened into the car seat. The headrest must be
18
All manuals and user guides at all-guides.com
(G)
to release the strap.
(E)
.
(F)
in order to give the
adjusted so that the harness (which moves with the headrest)
is at shoulder height on the child or slightly above, but never
behind the back or at ear level (5.2).
1. Pull the headrest height adjuster
height in accordance with the size of the child (fig. 5.1).
6. FastenInG tHe cHIld Into tHe seat Group 2 and 3.
Removing harnesses and the safety buckle
1. Release the harness protectors
hold them in place from the fastener at the back of the seat
(fig. 6.1/A).
2. Locate the harness connector on the lower back part of the
seat. Release the straps from the connector by unfastening
them (fig. 6.1/B) and remove them by pulling on them from
the front of the seat (fig. 6.2).
3. Turn the child seat over and from underneath the seat, remove
the harness straps by passing the lock plate through the slot
on the seat (fig. 6.2/A). The harness straps will be released.
4. Repeat these steps to remove the safety buckle from the seat
(D)
(fig. 6.2/A).
Fastening the child into the seat
1. Place the child seat on the car seat.
2. Sit the child on the seat and then fasten the car seatbelt,
inserting it into the buckle until you hear a click. Ensure that
the abdominal strap goes underneath the armrests (fig. 6.4/B).
3. Thread the diagonal part of the belt through the diagonal belt
guide until it is securely in place (fig. 6.4/A). Make sure that it
is not twisted.
As the child grows, the headrest height must be adjusted. In order
to do this, the steps outlined in point 5 must be followed.
(A)
and move it to shoulder
(c)
by removing the straps that
19