Tennant LPTB03540 Manual De Instrucciones página 10

MOVEMENT AND INSTALLATION
Lifting and transporting the packaged
machine
! WARNING
During all lifting operations, make sure the packaged machine is
Always load/unload lorries in adequately illuminated areas.
The machine is packaged on a wooden pallet by the Manufacturer. It
must be loaded onto the transporting vehicle using suitable equipment
(see EC Directive 2006/42 and subsequent amendments and/or addi-
tions). At destination, it must be unloaded using similar means.
A fork lift truck must always be used to lift the packaged body of the
machine. Handle with care to avoid knocking or overturning the machine.
Delivery checks
When the carrier delivers the machine, make sure the packaging and ma-
chine are both whole and undamaged. If the machine is damaged, make
sure the carrier is aware of the damage and before accepting the goods,
reserve the right (in writing) to request compensation for the damage.
Unpacking
! WARNING
When unpacking the machine, the operator must be provided with
the necessary personal protection devices (gloves, goggles, etc.) to
limit the risk of accident.
Proceed as follows to unpack the machine:
Cut and remove the plastic straps using scissors or nippers.
Remove the cardboard packaging.
Remove the bags from the battery compartment and check their
contents:
this Operator's Manual, Battery Charger Operator's Manual;
Wall Chart; Machine Battery Selection Instruction; Charger Set-
ting Instructions; Warrenty Replay Card.
Battery bridges with terminals.
1 connector for battery charger.
2 electronic keys.
Remove the metal brackets that secure the front wheels and the
machine's chassis to the pallet. To remove the metal bracket
rotate the tank backwards, then proceed with dismantling.
let. The machine must not be raised.
Unpack the brushes from their packaging.
Clean the outside of the machine, taking care to respect safety
regulations.
Once the machine is clear of the packaging, proceed to install the batter-
ies (see the "Batteries: installation and connection" section).
The packaging may be kept as it can be reused to protect the machine if
it is moved to another site or to a repair workshop.
Otherwise it must be disposed of in compliance with current legislation.
Batteries
Leak-proof tubular batteries (WET): these require regular checks
on electrolyte level. When necessary, top up with distilled water
above the plates).
Gel or AGM batteries: this type of battery requires no mainte-
nance.
Battery technical characteristics must correspond to those listed in the
Technical characteristics section. The use of higher capacity batter-
ies could seriously jeopardise manoeuvrability and lead to the drive mo-
tor overheating. Batteries with a lower capacity and weight will require
charging more frequently.
Batteries must be kept charged, dry and clean and the connections must
be kept tight.
The battery is a sealed unit and guaranteed safe under normal circum-
Contact with the skin can cause irritation; wash with soap and
water.
Inhalation of vapours can cause irritation to the airways; stay out
in the open air and consult a doctor.
water immediately and thoroughly for at least 15 minutes, and
consult a doctor.
Do not use NON-rechargeable batteries
Setting the battery type on the machine
Where machines are shipped without batteries, the machine is fac-
Depending on the type of battery selected (WET or GEL / AGM), the
from the factory setting.
! INFORMATION
for the type of batteries installed:
see the "Technical menu section"
Battery Charger Settings
-
Where machines are shipped without batteries, the machine and the
battery charger are factory set for Wet Lead-Acid batteries as the
tery, the battery charger setting MUST be changed as described be-
low. Failure to observe these instructions could result in damage to
the battery. Depending on the type of battery selected (WET or GEL
/ AGM), the battery parameters of the machine MUST be adjusted
"Technical menu section".
EN
! WARNING
! WARNING
! WARNING
-
10