Create Wind Flowood Manual De Instrucciones página 12

LIGH T I NSTALL AT IO N
• Install the bulb (not included) suitable for this type of fan.
• Attach the shade to the motor by inserting the glass neck into the light fixture, keeping two
spring clips inside the glass neck. Pull the glass screen toward the third spring clip. Push
the third clip to fit inside the glass and push the glass into the mounter.
• Assemble the decorative key ring and extension chains from the hardware bag to the fan
pull chains by inserting the end of the chain into the chain coupling. Confirm that the chains
are secure by lightly pulling on both chains on the coupling.
C HAIN AS SE MB LY
Hook the peg on the end of the chain into the slot and pull to tighten. Afterwards, you can
turn on the electricity and enjoy your new fan.
C H EC K I N STAL L AT IO N
• Check the correct operation of the ceiling fan, checking that no strange movement or mis-
alignment is observed in any part of the fan.
• If you notice any type of hum/vibration, you can proceed to adjust the blades with the bal-
ancing kit.
• This kit has self-adhesive counterweights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check to see if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip on
another blade or use the adhesive weights.
E NGL I SH
12