Midea MDRT489MTE Serie Manual De Usuario página 12

Hole cover
3. Unscrew the hinge screw, take off the middle hinge and the upper shaft sleeve, depart the
two hinge hole covers (plug pins) on the middle hinge, and take out the door body of the
refrigerator chamber upward.
4. Install the hinge shaft and shaft sleeve to the left hole of the lower hinge, and then
the lower hinge to the left corner of the refrigerator, then adjusting foot A according
to the position shown in the Figure, and finally the adjusting foot B to the right lower
corner of the refrigerator.
Adjusting Sleeve
foot A
Lower hinge
Adjusting foot B
5. Dismantle the door stop of the two door bodies and the self-locking screws of right door,
then take out the self-locking of left door from the accessory bag and install it to the left
corner of the door body together with the door stop; take out the bottom support block
of the door body of refrigeration chamber and install it to the lower left corner,Finally
take out the hole plug and shaft sleeve for the door of refrigeration chamber and adjust
their positions, and then install them into the door body. take out the right decorative
cover on the door of refrigeration chamber, and take out the left decorative cover from
the accessory bag and install it.chamber, and take out the left decorative cover from the
accessory bag and install it.
Hinge cover
Plug pins
Upper hinge
Sleeve
Adjusting
foot A
Adjusting foot B
07
Screw
Sleeve
Middle hinge
EN