Create Wind Wood Manual De Instrucciones página 10

HANGER BAR INSTALLATION
Choose the hanger bar that best suits your situation: a 15 cm hanger bar and a 25 cm hanger
bar are available.
Remove the bolt from the bar by removing the pin and thread the canopy (roof trim) and mo-
tor canopy through the hanger bar. Next, route the fan motor wires through the inside of the
hanger bar. Fit the hanger bar to the engine and insert the bolt and cotter pin.
Standard mounting
This fan can be installed in either a regular or vaulted ceiling, and you can extend the hang-
ing length with the longer hanging bar (supplied). To install the hanger bar you will need
the following tools: a screwdriver, a flathead screwdriver, adjustable pliers or a wrench, a
stepladder, wire cutters, and electrical tape.
Route the fan wires from the motor, through the hanger bar, decorative cover, and canopy to
the ceiling.
Advice: Applying a small piece of electrical tape to the ends of the wires will help hold them
together as you run them through the hanger bar.
SUSPENSION BAR INSTALLATION
• If you want to extend the hanging length of your fan, remove the ball from the hanger rod
and use the additional extension rod (included).
E NGL I SH
10
Lcking pin
Angle mounting
Cabling
Floron
Extension
bar
Trim
Cap screw
Fixing screw