Create Wind Wood Manual De Instrucciones página 12

1. Lift the canopy onto the mounting bracket and align the loosened screws on the mounting
bracket with the holes in the canopy.
2. Turn the finial to adjust it. Reinsert the screws and secure them with a screwdriver.
3. Once you have the mounting bracket secured to the junction box you can proceed to hang
the fan.
4. Grip the fan firmly with both hands. Pass the bar through the opening in the mounting
bracket and allow the ball to rest on the mounting bracket.
5. Rotate the ball coupling until it lines up with the tab on the mounting bracket.
Advice: Another person should help you hold the ladder and hand you the fan once you have
climbed the ladder.
BLADE INSTALLATION
Mount the blades on their metal support using the supplied screws and washers.
Align the holes in the blade holder with the holes in the blades and in the motor body and screw
them into place, but do not tighten the screws until they are all in place and screwed on.
Advice: To save time, you can put the washers on each screw before you install the blades.
CHECK THE INSTALLATION
• Check the correct operation of the ceiling fan, checking that there is no strange movement
or misalignment in any part of the fan.
• In the event that some type of buzzing/vibration can be seen, you can proceed to adjust the
blades with the balancing kit.
• In this kit you have self-adhesive weights and "u" clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip on
another blade or use the adhesive weights.
E NGL I SH
12