3M PELTOR ComTac VIII Headset Manual Del Usuario página 7

EN
The typical period of continuous use that can be expected
from the earmuff battery is approximately 50 hours with
Level-Dependent attenuation.
• This product may be adversely affected by certain chemical
substances. Further information should be sought from the
manufacturer.
• The product is not suited for high continuous noise levels.
• The wired connection of the product may not be used for
entertainment audio since the output level is not limited to
the necessary innocuousness level.
• The output of the audio circuit of this hearing protector may
exceed the exposure limit level.
2.2. CAUTION
• Risk of explosion if battery is replaced by an incorrect
type.
• Do not charge batteries in temperatures above 45°C
(113°F).
• Only use AA or AAA non-rechargeable (as applicable) or
3M™ PELTOR™ Ni-MH rechargeable LR6NM or LR03NM
(as applicable) batteries. These rechargeable batteries
might not be available in all markets.
• With Lithium ion batteries, there is a risk of fire and burns.
Do not open, crush, heat above 55°C (131°F), or incinerate.
• Always use product-specific 3M replacement parts. Use of
unauthorized replacement parts may reduce the protection
you receive from this product.
2.3. NOTE
• When worn according to these User Instructions, this
hearing protector helps reduce exposure to impulse noises,
such as gunfire. It is difficult to predict the required and/or
actual hearing protection obtained during exposure to
impulse noises. For gunfire, the weapon type, number of
rounds fired, proper selection, fit and use of hearing
protection, proper care of hearing protection, and other
variables will impact performance. To learn more about
hearing protection for impulse noise, visit www.3M.com/
hearing.
• This hearing protector is provided with electrical audio
input and level-dependent attenuation. The wearer should
check correct operation before use. If distortion or failure
is detected, the wearer should refer to the manufacturer's
advice for maintenance and replacement of the battery.
• This hearing protector is provided with safety related audio
input. The user should check correct operation before use.
If distortion or failure is detected, the user should refer to
the manufacturer's advice for maintenance.
• Operating temperature range: -40°C (-40°F) to 55°C
(131°F).
• In freezing temperatures, warm up the earmuffs before use.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon zink), or
rechargeable batteries.
• To properly dispose of the battery, follow local solid waste
disposal regulations.
2
• Only use non-rechargeable AAA Alkaline or rechargeable
LR03NM Ni-MH or non-rechargeable LR03L Lithium
batteries.
• Attention – Product imagery is for illustration only.
3. APPROVALS
All the approvals referred in this section might not apply to
your product. If some approvals don't apply to your product,
this can be seen on the label(s) on the product.
3.1. EU APPROVALS
EU
Hereby, 3M Svenska AB declares that the PPE type hearing
protector is in compliance with Regulation (EU) 2016/425 and
other appropriate directives to fulfill the requirements for the
CE marking.
The PPE is audited annually by SGS Fimko Ltd., Takomotie
8, FI-00380 Helsinki, Finland, Notified Body No. 0598, and
type approved by PZT GmbH, Notified Body No. 1974,
Bismarckstrasse 264 B, 26389, Wilhelmshaven, Germany.
The product has been tested and approved in accordance
with EN 352-1:2020, EN 352-4:2020, EN 352-6:2020.
The applicable legislation can be determined by reviewing the
Declaration of Conformity (DoC) at www.3M.com/peltor/doc.
The DoC will also show if some other type-approvals are also
applicable. When retrieving your DoC, please locate your part
number. The part number of your earmuffs can be found at
the bottom of one cup. An example can be seen in the picture
below.
YYYY/MM
XXXXXXXXXX
A copy of the DoC and additional information required in the
Regulations and Directives can also be obtained by
contacting 3M in the country of purchase. For contact
information, see last pages of this user instruction.
4. EXPLANATION OF STANDARD
TABLES
The sound attenuation was obtained with the device powered
off.
4.1. EUROPE AND ANZ
3M strongly recommends personal fit testing of hearing
protectors. Research suggests that users may receive less
noise reduction than indicated by the attenuation label
value(s) on the packaging due to variation in fit, fitting skill,
and motivation of the user. Refer to applicable regulations
and guidance on how to adjust attenuation label value(s). In
the absence of applicable regulations, it is recommended that
the attenuation label value(s) be reduced to better estimate
typical protection.