Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. Insert the batteries into the battery compartment according
to the illustration.
4. Close the battery cover.
5. Push the battery cover towards the earcup until a click is
heard.
7.
FITTING INSTRUCTIONS
Inspect the hearing protector before each use. If damaged,
select an undamaged hearing protector or avoid the noisy
environment.
7.1. HEADBAND
1. Put the earmuffs in position over your ears.
NOTE: Make sure that the headband is in position across the
top of your head.
2. Hold the earcup and push the headband wire up or down.
7.2. FITTING THE SPEECH MICROPHONE
To maximize the performance of the communication
microphone in noisy areas, position the communication
microphone very close to your mouth (< 3 mm / < 1/8 in.).
NOTE: When used in high altitudes/aviation the surrounding
pressure can be reduced rapidly and affect the
communication microphone sensitivity, for example during
helicopter ascent. If this occurs position the microphone
closer and/or speak louder to increase the pressure on the
communication microphone membrane.
4
7.2.1. TO ADJUST THE MICROPHONE
1. Fold the microphone towards the corner of your mouth.
2. Release the adjustable screw.
3. Set the distance of the microphone, < 3 mm / < 1/8 in.
4. Tighten the adjustable screw.
7.3. APPLYING MIKE PROTECTOR TAPE
NOTE: For best performance, replace the protective tape
when damaged, dirty or deformed.
1. Cut approximately 10 cm/4 in. of the protective tape. Refer
to "13. Spare parts and Accessories".
2. Remove the backing from the protective tape.
3. Wrap the protective tape around the microphone.
4. Apply pressure to the protective tape.
<3 mm
Publicidad
