Tabla De Contenido - Roger Technology B70/2DC Instrucciones Y Advertencias Para El Instalador
Centrale di comando 2 motori
Ocultar thumbs
Ver también para B70/2DC:
- Instrucciones y advertencias para el instalador (220 páginas) ,
- Instrucciones y advertencias para el instalador (220 páginas) ,
- Instrucciones y advertencias para el instalador (38 páginas)
Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
TABLE OF CONTENTS
1
Introduction to the instructions and
warnings
2
Product technical characteristics
3
3.1
3.1.1
3.2
3.3
3.4
3.5
3.5.1
3.5.2
3.5.3
3.5.4
4
4.1
4.2
4.3
4.4
4.5
4.6
5
6
7
2
Technical product characteristics B70/2DC
SUPPLY VOLTAGE
MAXIMUM POWER CONSUMPTION
CONNECTIBLE MOTORS
POWER SUPPLY MOTORS
MOTOR TYPES
MOTOR CONTROL TYPE
RATED POWER FOR MOTOR
MAXIMUM POWER FOR MOTOR
MAXIMUM POWER FLASHING
INTERMITTENT FLASHING
MAXIMUM POWER COURTESY LIGHT
GATE OPEN LIGHT POWER
ELECTRIC LOCK POWER
ACCESSORIES OUTPUT POWER
OPERATING TEMPERATURE
DEGREE OF PROTECTION
PRODUCT DIMENSIONS
20
pag.
1
Introduction to the instructions and warnings
20
This manual is only intended for personnel
20
qualified to perform the installation.
21
No information contained in this document may be
21
considered of interest to the end user.
22
This manual refers to control panel B70/2DC for
22
automations comprising 1 or 2 ROGER brushless
22
motors and should not be used for other motors.
22
22
23
23
24
WARNINGS
25
To avoid the risk of electrocution and physical injury
always cut the power before intervening on the
25
device.The installation must only be carried out by
25
qualified service personnel according to applicable
25
regulations.Make the connections to the currents
26
and voltages required with the appropriate cables;
26
observe the product's technical characteristics.
27
Check the conformity of the earth system and the
27
continuity between the earth on the motor side and
27
the control unit's terminal block.
28
The same type of motors must be used for both
28
wings.The slowdowns can be set independently:
ensure that they are appropriate for the type of
37
installation, in order to prevent the wings from
37
overlapping.
37
230Vac ± 10% 50Hz
350W
2
24Vac with self-protected invert
brushless sinusoidal (ROGER BRUSHLESS)
Field oriented control (FOC), sensorless
40W
110W
25W (24Vdc)
50%
100W 230Vac - 40W 24Vac/dc (pure contact)
3W (24VDC)
15W (12VDC)
10W (24VDC)
-20°C ... +60°C
IP54
Dimension in mm. 330 x 230 x 115 Weight: 3,9Kg
Read the
instructions
carefully before
starting the
installation.
ELECTROCUTION
HAZARD
Publicidad
Capítulos
Tabla de contenido
