Publicidad
Idiomas disponibles
Idiomas disponibles
ELM2L
EMERGENCY LIGHTING UNIT
Installation and wiring ....................................................................................... P. 2-5
Testing and maintenance ..........................................
NOTE: Product versions that comply with CA Title 20 are marked BC on the product label.
!
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR
SIGNIFICANT PROPERTY DAMAGE
maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations. If you do not understand
!
these instructions or additional information is required, contact Lithonia Lighting or your local Lithonia Lighting distributor.
WARNING:
RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM OR SERVICE WHILE EQUIPMENT
IS ENERGIZED
!
.
WARNING:
DO NOT USE ABRASIVE MATERIALS OR SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIXTURE,
WHICH MAY RESULT IN PERSONAL INJURY.
!
WARNING:
RISK OF PERSONAL INJURY
from carton, handling, installing and maintaining this product.
!
WARNING
:
The battery used in this device may present a risk of fire or chemical burn if mistreated. Do not disassemble, heat above 70° C
(158° F), or incinerate. Replace battery only as directed on the battery label and page 5 of these instructions. Use of unauthorized battery voids
warranty and UL listing of this product and may present a risk of fire or explosion.
•
Disconnect A.C. power before servicing.
•
All servicing should be performed by qualified personnel.
•
Consult your local building code for approved wiring and installation.
•
Do not use outdoors unless used with Acuity Brands accessories appropriate to the application.
•
Do not mount near gas or electric heater.
•
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
AND DELIVER TO OWNER AFTER INSTALLATION
(120/277V, 220-240V, 120/347V)
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
Should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
- For your protection, read and follow these warnings and instructions carefully before installing or
–
This product may have sharp edges. Wear gloves to prevent cuts or abrasions when removing
SAVE THESE INSTRUCTIONS
(Nicad_Standard)
........................................P. 6-7
"TEST" button /
indicator
status
Press latches to disengage
housing from mounting plate
Publicidad
