Publicidad
Idiomas disponibles
Idiomas disponibles
LAMP REPLACEMENT
Remove lamp bezel as shown below.
1
Bezel
Collar
Carefully flex this edge &
free from collar button
CHARGER BOARD REPLACEMENT
With the unit oriented as in the below
1
view, flex the channel at the left end
of the charger board outward to
release and remove it. Unplug the
battery and other connections. See
"Lamp
Replacement"
disconnect the lamp wires from the
charger board.
TESTING and MAINTENANCE (CONTINUED)
Gently bend the snap at each side of
2
the collar outward to release the lamp
assembly. Cut wires near lamp board
and strip back 1/4in. Connect stripped
wires to the replacement lamp,
following the yellow/blue polarity as
marked.
Collar button
Connect the lamp wires to the new
2
charger board, following the yellow/blue
polarity as marked. Reconnect the
battery and other components (if
included). For insertion of PCB, insert
above,
to
right side (1) of PCB first, followed by
left side (2) (click should be heard).
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
techsupport-lighting@acuitybrands.com
Release snaps
gently
Connector under
the PCB
2
1
www.lithonia.com
Replace the lamp assembly firmly
3
under the snaps on the collar,
making sure the lamp wires are not
pinched. Replace the bezel.
Yellow
Blue
(-)
Cut wires near
Lamp board
Make sure all wires are routed as
3
before, so as not to interfere with
proper assembly of the housing
onto
the
mounting
assemble the unit (see also step 5
& 6, page 4).
Part # 912-00026-006
© Acuity Brands Lighting, Inc. 2018
page 7
(+)
plate.
Re-
Rev.E, 02/14/2024
All Rights Reserved.
Publicidad
