Publicidad
Idiomas disponibles
Idiomas disponibles
CONDUIT SURFACE MOUNTING
NOTE: to avoid interference with components in the housing, use the most compact wire connectors appropriate to the wire gauge
1.
At upper center of the mounting plate, remove the conduit connection knockout. Remove required keyhole slots from mounting
plate to support the product on the given wall type.
2.
See Wiring Diagram, page 5. Make code-approved wire connections to the branch circuit and remote lamps (if applicable). Dress
wires into slots so that the connectors are secured as shown in Figure 2 or Figure 3.
Figure-2
3.
Remove U-shaped knockout from top center of housing. Hint: Use a pair of wire cutters first to start a cut in the thick portion at
each side of the knockout, then finish breaking it out with pliers.
.
INSTALLATION and WIRING (CONTINUED)
Secure wire connectors near the centre or near the upper latches.
AVOID grouping wires and wire nuts in the area of the PCB and the
battery as this may limit engagement of connector to PCB.
Cut
Orient conduit fitting so
all portions of it clear the
edge of the knockout
Figure-3
After knockout
Washer
Battery
Use
washer(s),
like
(Grainger
between conduit fitting and rear housing, if
conduit fitting interferes with battery. The
purpose of the washer is to have as few
threads inside of the housing as possible.
page 3
removal
#4DAX6),
Publicidad
