Suncast BMS2500 Instrucciones De Armado página 4

A
Care Instructions
• At regular intervals, ispect your shed to make sure that assembly integrity has been maintained.
Repair or replace broken parts immediately.
• Periodically check that the location you have chosen to set you shed is still level.
• Keep roof clean of snow and leaves.
• To maintain the look of your product, we recommend cleaning it at regular intervals with mild soap
and water.
DO NOT
use bleach, ammonia, or other caustic cleaners, and
DO NOT
use stiff bristle
brushes. Failure to perform cleaning at regular intervals could result in permanent staining of the
plastic. This is not a manufacturing defect and is not covered under warranty.
A
Assembly Day Tips
• This item uses self- tapping screws in some areas. There are no pre- drilled holes in the plastic.
Use force when starting to drive the screw. Once the screw pierces the plastic it will drive
easier.
• DO NOT attempt to assemble on a day with strong winds.
• Set aside appropriate amount of time to completely assemble shed. An incomplete assembly
may pose a safety hazard.
• Make sure you have assistance nearby to lift and secure parts in place.
• Once roof is assembled, a flashlight may be of use when assembling smaller components
inside shed.
• Suncast provides extra hardware for small fasteners for customer convenience. In some cases,
there will be extra small fasteners once the assembly is complete.
Note: This product contains parts that are used in different orientations to construct the shed. Please take
note of the orientation of the parts shown throughout this instruction manual. Failure to follow instructions
could result in damage to parts. Suncast is not responsible for replacing parts lost or damaged due to
incorrect assembly.
4