Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING TIPS
•
To extend battery life per charge, turn the laser level off
when it is not in use.
•
Lowering the brightness of laser level increases battery life.
•
To ensure the accuracy of your work, check the laser level
calibration often. Refer to Checking laser Accuracy.
•
Before attempting to use the laser level, make sure it is
positioned securely, on a smooth, flat stable surface that is
level in both directions.
CAUTION: To reduce the risk of serious injury,
never stare directly into the laser beam with or
without glasses.
•
Always mark the center of the beam created by the
laser level.
•
Extreme temperature changes can cause movement or
shifting of building structures, metal tripods, equipment,
etc., which can affect accuracy. Check your accuracy often
while working.
•
If the laser level has been dropped, check to make sure
your laser level is still calibrated. Refer to Checking
laser Accuracy.
Turning the Laser On (Fig. C)
Your laser level is equipped with a three‑position pendulum
lock/unlock and power switch
•
horizontal position: Power off
•
Middle position: Manual Slope Mode (Power On,
Pendulum Locked)
Vertical position: Self‑Leveling Mode (Power On,
•
Pendulum Unlocked)
The laser beams will turn on automatically if the pendulum
lock/unlock and power switch is moved from the horizontal
position to either the middle position or the vertical position.
Self‑Leveling Mode
When the switch is placed in the vertical position, the laser
will self‑level as long as the surface the laser level is placed
on is less than 4 ° tilt.
.
13
With the laser level off, place it on a flat surface. This model
has a keypad to activate the laser beams with two buttons;
one for a horizontal laser line
laser line
12
. Each laser line is powered on by moving the
pendulum lock/unlock and power switch to the UNLOCKED/
ON position and pressing the required laser line button on
the keypad. The laser lines can be powered one at a time or
at the same time. Pressing the laser line buttons again turns
the laser lines off. The pendulum lock/unlock and power
switch disables the lasers as well as locks the pendulum, and
should always be placed in the LOCKED/OFF position when
the laser level is not in use.
Manual Slope Mode
When the switch is placed in the middle position, the laser
unit is in manual slope mode. The laser will not self level in
this mode and is used in situations where a fixed laser line
is required.
nOTE: The laser is NOT LEVEL when the pendulum lock
indicator
is illuminated, and the beams will flash 3 times
8
every 10 seconds to further indicate this.
Laser Line Brightness (Fig. A, O)
The brightness of the laser lines can be adjusted by pressing
the brightness control button
brightness level
on the remote (DCLE14201G only; Refer
27
to Using the DCLEAUSBRC1 Remote Control). This will cycle
through high, medium, and low brightness.
Rotating the Laser Head (Fig. D)
The laser head
2
is permanently attached to the laser level
base. This laser head can be manually rotated by hand by
gripping the laser head and rotating, or by using the fine
adjust knob
14
for smaller, more precise movements.
Using the DCLEAUSBRC1 Remote Control
(Fig. A, C, O)
DCLE14201G Only
WARNING: Do not operate the laser level via remote
control when not in the same room or in presence of
English
11
and one for a vertical
7
button on the keypad or the
11
Publicidad
