Publicidad
Idiomas disponibles
Idiomas disponibles
English
the laser level.
The remote control
22
allows one person to set up and
operate the laser level from a distance.
To pair a new remote control or re‑pair an old remote control
with the laser level:
1. Remote can be paired within 60 seconds of powering ON
the laser. Hold down the remote link button
light
24
on the remote control will blink blue when in
pairing mode.
nOTE: When remote is in sleep mode, remote control
link indicator LED
on laser keypad will turn off.
9
Pressing any button aside from remote link button on
remote will turn on remote (awake from sleep) and laser
keypad light (remote control link indicated LED) turns on
blue LED.
2. When the remote control is paired, the LED light
the remote will remain solid blue for two seconds, and
remote control link indicator LED
will light up solid blue.
The functions on the remote keypad are identical to the
functions on the laser level itself (horizontal laser line on/off
button
, vertical laser line on/off button
25
control
27
).
lED lighT DiAgnOsis
Remote control is in sleep mode.
OFF
(Not Engaged)
FLASHES RED
Unsuccessful press of any button
THREE TIMES
aside from remote link button.
Successful press of any button
FLASHES BLUE
aside from remote link button.
12
. The LED
23
24
on
9
on the laser keypad
, brightness
26
sOlUTiOn
Press any button other
than remote link button.
Move closer to the laser
level and press a function
button on the remote. If
the issue still exists, try to
re‑pair the remote.
lED lighT DiAgnOsis
FLASHES BLUE
LED ONCE
Low battery and successful press
FOLLOWED BY
of any button aside from remote
RED LED BLINK
link button.
FOR THREE
SECONDS
FLASHES
Low battery and unsuccessful
RED FOR TEN
press of any button aside from
SECONDS
remote link button.
nOTE: The remote control will go into sleep mode after
60 seconds. Selecting any button will reengage the remote
with the laser level.
nOTE: Environments with large amounts of metal structures
or radio interference may cause reduced remote control
range. For best range, keep laser unit and remote at least 5 feet
(1.5 m) above the ground.
Installing Batteries into the Remote Control
(Fig. O)
The remote control
22
is powered by two AA batteries
To install the batteries provided:
1. Lift up on the battery compartment cover
2. Insert two fresh AA (LR6) batteries into the battery
compartment
30
, placing the batteries according to the
(+) and (‑) marked inside. On successfully installing the
batteries, the LED light
nOTE: For long battery life, always replace old batteries with
an unused set of AA (LR6) batteries.
WARNING: Batteries can explode, or leak, and can
cause injury or fire. To reduce this risk:
•
Carefully follow all instructions and warnings on the
battery label and package.
•
Always insert batteries correctly with regard to polarity (+
and –), marked on the battery and the equipment.
•
Do not short battery terminals.
•
Do not charge batteries.
sOlUTiOn
Replace AA (LR6)
batteries
.
29
stays solid blue for 5 seconds.
24
28
.
Publicidad
