Publicidad
Idiomas disponibles
Idiomas disponibles
English
•
Always unplug the USB cable from the power supply
when there is no tool attached to it.
Charging Procedure (Fig. A, B)
WARNING: The power adapter MUST be a Class
2 power supply.
1. Pull the USB charging port cover
the laser level.
2. Insert the USB cable
15
3. Plug the USB cable
15
4. Plug the power supply into a wall outlet.
5. Charging is complete when all three bars of the battery
meter
10
light up on the side of the laser level. The
battery can be left charging or the USB cable can
be disconnected.
Important Charging Notes
1. The laser level may become warm to the touch while
charging. This is a normal condition, and does not
indicate a problem. To facilitate the cooling of the
laser level after use, avoid placing the laser level in
a warm environment such as in a metal shed or an
uninsulated trailer.
2. If the laser level does not charge properly, take the laser
level and USB cable to your local service center.
3. You may charge a partially used battery whenever you
desire with no adverse effect on the laser level.
nOTE: The laser level may be used while charging.
Hot and Cold Condition
On charging, when the temperature is 125 °F (52 °C)
or higher (hot condition) or 32 °F (0 °C) or colder (cold
condition), the charging is turned off and the following
battery state of charge pattern will flash:
10
5
away from
into the charging port
17
into power supply
16
.
Until the temperature is between 122 °F (50 °C) and 32 °F
(0 °C), the charging will not turn on and the indication shown
above will continue.
Viewing the Battery Meter (Fig. A, C)
When the laser level is ON, the state of battery meter
the keypad indicates how much power remains.
•
All three LEDs will flash when the battery level is low
(< 10%). The laser level may continue to operate for
.
a short time while the battery power continues to drain.
•
After the battery is charged, and the laser level is turned
ON again, the battery indicator level will indicate
full capacity.
•
If any or all of the LEDs on the battery meter remain ON,
this indicates that the laser level is not fully powered
OFF. When the laser level is not in use, make sure the
pendulum lock/unlock and power switch
the DOWN Locked/OFF position.
BATTERY
METER lED
sTATE OF ChARgE
Battery is 80%–100% charged
Battery is 50%–80% charged
Battery is 10%–50% charged
Battery is < 10% charged
Battery is < 10% charged, unit is charging
10
on
is placed to
13
Publicidad
