Publicidad
Idiomas disponibles
Idiomas disponibles
4.4.1 - Autolearning of the travel stroke and main parameters
1. Unlock the gear motor, bring the gate to approximately half its travel and lock the gear motor again.
2. To start the auto-learning procedure, simultaneously press and hold the
buttons; after approximately two seconds the gate begins to open slowly; the display shows
!
WARNING
If the leaf moves in the closing direction, stop the movement by pressing the
(DOWN-RADIO) button; press the
direction of movement reversed.
3. Once the opening limit switch is reached the motor stops. After approximately two seconds the gate
begins to move towards the closing direction; the display shows
4. The stroke auto-learning operation ends when the closing limit switch is reached.
!
WARNING
The travel auto-learning operations must be fully and correctly completed before
putting the equipment into operation; their interruption is only possible by intervening on the safety
devices (EDGE, PH2, PH1) or by cutting off power to the control unit.
5. After having correctly completed the travel auto-learning procedures, perform a few complete opening and closing manoeuvres of
the gate to check its correct functioning.
After having successfully completed the auto-learning it will be possible to modify the operating parameters by accessing the
or
parameters menu (paragraph 5)
4.4.2 - Autolearning of the travel stroke and main parameters, with customised decelerations
The default low speed travel length is 20% of the total travel length. It is possible to change the default value of the travel width
performed at low speed, both in opening and closing, by acting on the
(customised). See paragraph 5.1, point 10
1. Unlock the gear motor, bring the gate to approximately half its travel and lock the gear motor again.
2. To start the learning procedure, simultaneously press and hold the
for approximately two seconds; after around two seconds the gate slowly begins to move towards the
opening direction; the display shows
!
WARNING
If the gate moves in the closing direction, stop the movement by pressing the
(DOWN-RADIO); button; press the
direction of movement reversed.
3. Once the opening limit switch is reached the motor stops. After approximately two seconds the gate
begins to move towards the closing direction; the display shows
4. Having reached the point where it is necessary to start the slowing down phase (in closing), press the
SBS button (
); the display shows
5. Once the closing limit switch has been reached, the motor stops and after approximately two seconds
it starts moving again towards the opening direction; the display shows
6. Having reached the point where it is necessary to start the slowing down phase (in opening), press the
SBS button (
); the display shows
7. Once the opening limit switch has been reached, the motor stops; subsequently the closing
manoeuvre is performed. When the gate is closed again, the auto-learning procedure of the travel with
customised slowdown points is finished.
WARNING
!
If during the various opening/closing manoeuvres one of the deceleration points is
not set, it will automatically be set to 20% of the total travel length.
!
WARNING
The travel auto-learning operations must be fully and correctly completed before
putting the equipment into operation; their interruption is only possible by intervening on the safety
devices (EDGE, PH2, PH1) or by cutting off power to the control unit.
After having successfully completed the auto-learning it will be possible to modify the operating parameters by accessing the
or
parameters menu (paragraph 5)
(SBS) button to resume the learning procedure with the
(UP) and
(SBS) button to resume the learning procedure with the
(UP) and
((MENU)
parameter in the
(MENU) buttons
EN
and/
menu by selecting P
and/
11
Publicidad
