See the engine manual for the full list and frequency.
1)
At the first signs of any malfunction, contact your Dealer immediately.
2)
The operation must be carried out by your Dealer or a specialized Service Centre.
3)
General lubrication should also be carried out whenever the machine is to be left
4)
unused for a long period.
6.2.1 Engine
Follow the instructions in the
engine booklet.
Drain the engine oil by unscrew-
ing the oil fill plug (1) and using
the syringe supplied.
Fit the pipe (2) onto the syringe
(3) and insert it right into the
hole.
Drain all the engine oil, repeat-
ing if necessary until there is no
oil left in the engine.
6.2.2 Rear axle
This is a sealed single unit that does not require maintenance. It is
permanently lubricated and its lubricant does not need changing or
topping up.
6.2.3 Battery
To ensure long life to the battery it is essential to keep it carefully
maintained.
3
1
2
The machine battery must always be charged:
– before using the machine for the first time after purchase;
– before leaving the machine for a prolonged period of disuse;
– before starting up the machine after a prolonged period of disuse.
– Carefully read and comply with the procedure for recharging
described in the booklet coming with the battery. If the procedure
is not followed or the battery is not charged, irreparable damage
could be caused to the elements inside the battery.
– A flat battery must be recharged as soon as possible.
IMPORTANT
Recharging must be done using a battery
charger at constant voltage. Other recharging systems can irre-
versibly damage the battery.
1
The machine has a connector (1) for recharging, to be connected to
the corresponding connector of the special "CB01" or "FIGHTER"
maintenance battery-charger supplied (
on request (
9).
IMPORTANT
This connector must only be used for con-
nection to the "CB01" or "FIGHTER" maintenance battery-charger.
For its use:
– follow the instructions given in the relative instruction booklet,
– follow the instructions given in the battery booklet.
1
if included) or available
EN
23