Publicidad
Idiomas disponibles
Idiomas disponibles
Currently activated operating mode
DMX start address and DMX mode
Press encoder =
Select operating mode (Mode)
SET DMX START ADDRESS (DMX Address)
Starting from the main screen, press the right rotary-push encoder to enter the main menu.
Turn the left encoder (SELECT) to select DMX Address (note the selection arrow on the left)
and confirm by pressing the encoder (ENTER). You can now configure the DMX start address as
required by turning the encoder (the highest value depends on the selected DMX mode). At the
same time, the DMX start address following the selected start address plus the channel number
of the selected DMX mode is displayed (following address). Confirm the entry by pressing the left
encoder (ENTER); this will also automatically take you back to the main screen and the DMX mode
will be activated. You can access the DMX mode selection menu directly from the DMX Address
menu by pressing the centre encoder (DMX Mode); the previously set DMX start address is saved
automatically.
Turn encoder =
Change value
Press encoder =
Confirm value change (Enter)
SET DMX MODE (DMX Mode)
Starting from the main screen, press the right rotary-push encoder to enter the main menu. Turn
the left encoder (SELECT) to select DMX Mode (note the selection arrow on the left) and confirm
by pressing the left encoder (ENTER). You can now select the desired DMX mode by turning the
14
= DMX signal is present
5CH RGBAL
001 (5CH of Mode)
following Address 006
Press encoder =
Select DMX mode (DMX Mode)
= no DMX signal
Fan mode
Press encoder =
Open main menu (Menu)
Press encoder =
Open main menu (Menu)
Publicidad
