John Bean B 300 Manual Del Operador página 20

1 2 3
4 5 6
20
7 8 9
4-6
Layout
4. + key
To increase an input value (e.g. rim diameter, offset,
10
rim width).
Hold down to change the value shown automatically.
5. Enter key
Press to confirm entered values (dimensions,
mode) or save user settings. The unit will beep.
6. - key
To decrease an input value (e.g. rim width, offset,
rim diameter).
Hold down to change the value shown automatically.
7. * key with indicator
Press to scroll along the special modes.
The * key indicator will light up, the unit will beep.
8. Fine key (Lens)
8. Fine key
Press to toggle the read-out accuracy between Normal,
Press to toggle the readout accuracy between 5 and
1 grams (0.25 resp. 0.05 oz.). The unit will beep. i.e. 0,25 oz (5 grams) and Fine i.e. 0.05 oz (1 gram)
Combined with the * key, it starts the calibration
regardless of the registered value. The unit will beep.
function.
Release the key to return to normal accuracy. Combined
with the * key, it starts the "user calibration" function.
9. Weight key
Press to select the required weight application
mode (wheel type), the unit will beep.
Combined with the * key, it starts the "user" function.
Note: If pressed for at least three seconds, it recalls
directly the Normal mode (Clip-Clip) and reduces
the number of ALU modes that can be selected
"Quick ALU Mode" (
10.Stop key
Press to stop the wheel measurement run.
Note:
The STOP key also acts as an immediate stop
switch.
F
5.8.1).
...