Publicidad
Idiomas disponibles
Idiomas disponibles
3.7 THE WATERWAY
INSTALLATION
Pre-installation
•
Install the water pipes away from
the hot source.
•
The minimum inlet water
pressure: 147KPa
•
The maximum inlet water
pressure: 834KPa.
NOTE
In order for the automatic ice-making and
the cold water supply to work normally,
you may need to buy a booster.
•
Ensure the pipes length is not
beyond 8 metres and be careful
not to kink together.
•
Please do not connect the
appliance to a tap of water heater.
Please do not bend inlet pipes
and drain-pipes when placing,
and shall carefully connect water
pipes.
connecting hose
joint
•
Do not use any old and used
water pipes. Please purchase the
joint to connect the pipe and the
water tap and install it according
to the schematic diagram
(Figure 1).
•
After being used for 6 consecutive
months, the icon (
panel will blink.
If that happens, please replace the
water filter.
Figure 1
Refrigerators
side
Refrigerators
back
) on display
The water filter installation and
replacement
•
Please refer to the user manual for
the position of water filter.
Remove the filter by turning it
•
clockwise (Figure.2).
•
Remove the packaging of the new
filter and make sure the o-rings
and properly positioned. Insert the
new filter into the lousing and lock
it by turning it counterclockwise.
Resetting the filter status:
•
After changing the water filter,
reset the water filter by pressing
and holding the
seconds. When the filter status is
reset, the corresponding icon
(
) will turn off from the display
panel.
NOTE
If you don't use the function of cool
water for a long time, please discard first
several cups of water (residual water in
water tank) before next using
24
Figure 2
button for 3
V.1
Publicidad
