VALBERG SBI 14S44 C SAD929C Instrucciones De Uso página 31

B
Using the appliance
2. Pour the rinse aid into the dispenser, being careful not to overfill.
3. Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by user. Follow the below steps.
1. Close the door, switch on the appliance.
2. Within 60 seconds after the appliance was switched on press the program button for more
than 5 seconds, and then press the Delay "+" button to enter the set model, the rinse aid
indication blinks as 1Hz frequency.
3. Press the Program button again to select the proper set according to your using habits, the
setting will change in the following sequence: d3->d4->d5->d1->d2->d3.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to complete the setup and exit
the setting mode.
31 EN