Oto Sew - Sears Kenmore 385.17324 Manual De Instrucciones

Automatic Buttonhole (Continued)
• To Sew
(_ Stitch selector: 2
(_ Stitch width: 2
(_ Stitch length: 3 to 4
(_ Needle thread tension: 2 to 6
(_) Presser foot: Bt_onhole foot
NOTE: Best results are obtained by using #60 or #80
lightweight thread for bobbin thread
It is advisable to use a #11 blue stretch needle
when sewing knits and synthetic fabrics°
You can obtain buttonholes with wider cutting
space by setting st;tch width at 1,5 instead of 2,,
Needle thread (Top thread)
(_ Bobbin thread (Bottom thread)
_) Two round holes
(_ Rectangular hole
Two pins fitting with the two round holes
(_ Lever
0 Hook fitting with the rectangular hole
(_ Base plate
Remove the extension table (accessory box). Raise the
needle to its highest position by turning the handwheel coun-
terclockwise° Remove the foot holder. Pull bobbin thread
about 3"(7,0 cm) straight back toward the rear of the ma-
chine. Insert the hook of the base plate 0 into the rectangu-
lar hole on the needle plate 6)° Pull lever ® back to align the
hook with the rectangular hole. Snap base plate ® down to
fit the two pins ® at the back of base plate into the two round
holes on needle plate (_ Release the lever°
Q
LENGTH ®
f
®
®
J
82