then turn on the power switch while holding the STOP button down until four digits are
shown on the display. When pressing ON, the two digits on the left can be changed, and
when pressing SELECT, the two on the right can be changed. Enter:
•
1001 Auto-programming (default mode)
•
1002 Manual Mode (controlled via the display)
•
4104 Self-Service mode (squeezing starts immediately when opening the tap)
•
4105 Self-Service mode (squeezing starts 1 second after opening the tap)
•
4106 Self-Service mode (squeezing starts 2 seconds after opening the tap)
When the required mode has been established by entering the relevant code, press STOP
and switch off the machine at the power switch. The entered mode will remain permanently,
even after switching the machine off again.
2. Auto-programming: In 1001 Auto-programming mode, one of the two operating modes can
be selected each time the machine is switched on without the need to enter a code:
•
Manual Mode (controlled via the display): Switch on the machine with the tap previously
set to the open position using the cam. The machine will then automatically change to
code 1002 Manual Mode (controlled via the display).
Warning: If the securing cam is removed at any time and the tap is closed, a filter tray
warning will be shown on the display with the text "CLOSED TAP".
The warning will disappear when the tap is set to the open position again, and the
display can be used to control the machine.
•
Self-service mode: Switch on the machine with the tap in the closed position. When
running it for 1 second, the machine will automatically switch to code 4105 Self-Service
mode (squeezing starts after 1 second when opening the tap).
Note: The display buttons will not work in this mode, and therefore squeezing can only
be started by opening the tap.
5.3.
CYCLE COUNTER FUNCTION
If you would like to know the partial number of cycles* the machine has performed, you
should press STOP once while the machine is switched on and in standby (not squeezing).
The display will show the number of squeezing cycles the machine has performed since the
last time it was reset.
If you would like to know the total number of cycles* the machine has performed, you should
press STOP twice while the machine is switched on and in standby (not squeezing). The
display will show the total number of cycles for a few seconds
machines are delivered after performing 600-650 test cycles during the quality control
process).
*Cycle = complete fruit squeezing manoeuvre.
(remember that all the
25