Zummo Z40 Manual De Usuario página 26

5.4. SELECT BUTTON LOCK FUNCTION
The machine features a system to lock the SELECT button, which prevents changes to the
number of programmed squeezing cycles.
To configure the lock, the machine needs to be disconnected at the power switch. When the
machine is switched off, press STOP and then turn on the power switch while holding the
STOP button down until four digits are shown on the display. When pressing ON, the two
digits on the left can be changed, and when pressing SELECT, the two on the right can be
changed. Enter:
•
7437 Selector Locked/Unlocked (depending on the status prior to performing this, and
where applicable the padlock symbol will be displayed.
When the required mode has been established by entering the relevant code, press STOP
and switch off the machine at the power switch. The entered mode will remain permanently,
even after switching the machine off again.
5.5. WASTE REMOVAL WARNING FUNCTION
The machine features a warning system to remind us to empty the waste containers after a
number of cycles set by the user have been completed.
To configure the waste removal warning, the machine needs to be disconnected at the power
switch. When the machine is switched off, press SELECT and then switch on the power switch
while holding the SELECT button down until the bins/chutes and three digits are shown on the
display.
By pressing SELECT we increase the number of cycles, and by holding SELECT down for
more than two seconds, we reduce this number.
When the required quantity has been established, press STOP and switch off the machine at
the power switch. The entered quantity will remain permanently, even after switching the
machine off again.
When the machine has completed the programmed number of cycles, it will stop and the
bins/chutes on the display will flash. To continue squeezing, the bins/chutes will need to be
removed and emptied. Then press ON again. The warning will be reset to zero at this point,
and will be displayed when the number of programmed cycles is reached again.
To disable this waste removal warning function, you should programme it again but enter
"000" in the quantity.
5.6. STANDBY
The machine features a low consumption mode for the display whereby after 5 minutes
without running, the light switches off and all the icons except the machine icon switch off.
26