Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the mower's operating time per day
-
The default daily operating time is 3 hours, but you can change it (the minimum time is 1
hour, and the maximum is 24 hours).
-
To do this, hold down the
time to be 06 hours, press the
flashes, press
mower will run for 6 hours a day from the start time you have set. You will hear a beep
when it starts up. Fig. 13
Changing the days of operation per week
-
By default, the mower will operate 5 days a week. You can change this setting to 3, 5 or 7
days. For example, imagine you want to select 3 days per week.
-
The number "05" will flash. Press the
and then press
3 = Monday, Wednesday and Friday.
5 = Monday, Tuesday, Wednesday, Thursday, and Friday.
7 = Monday, Tuesday, Wednesday, Thursday, Friday, Saturday, and Sunday.
-
By default, the mower will cut the edges skirting the boundary wire on Tuesdays and
Fridays. Remember that if you have the mower configured with 3 cutting days, Tuesday will
not perform edge cutting because it has not programmed that day in its operating range.
Rain sensor configuration
-
The mower has a built-in rain detection sensor. When this function is activated, it will stop
operation by default and return to its charging station until it stops raining and a preset
stipulated time has elapsed.
-
To access this menu and activate/deactivate this function, press, and hold the
for 3 seconds.
select the option ON or OFF on the display by pressing
confirm your selection.
Zone configuration
-
The mower has built-in intelligent navigation technology that enables it to start the cutting
task from a different point than the charging station. This function is highly recommended
to obtain a better result in the total coverage of the cutting area.
-
This option is by default on but can be changed by pressing the
and then pressing
press
to enter to select ON or OFF depending on whether you want to keep the function
on or off. To confirm the selection, press
-
The mower shall start from the second starting point after completing the total discharge
of the battery.
button for 3 seconds. For example, if you want the operating
or
to confirm the setting.
to confirm the setting. The following will appear on the display:
will appear on the display. Press
or
to switch from the
buttons to select the number (06) and, when
will appear on the display. The
or
button to select the desired number (03)
and
menu to the ZONE menu, and then
.
CONGA GRASSHOPPER 300
ENGLISH
to access the settings and
, and then press
button for 3 seconds
button
to
123
Publicidad
