cecotec CONGA GRASSHOPPER 300 Manual De Instrucciones página 124

ENGLISH
5. CLEANING AND MAINTENANCE
WARNING: before cleaning the mower, switch it off. Wear protective gloves before cleaning the
blade disc. It can be cleaned with water, but at low pressure (<1 Mpa).
Maintenance
- Clean and check the mower from time to time, some parts should be replaced when they
are worn. Turn off the mower before performing any maintenance.
- Keep blades sharp.
WARNING: before cleaning, adjusting, or changing blades, turn off the mower and put on
protective gloves.
WARNING: when fitting new blades, replace all of them (do not leave any of the old ones). It is
not necessary to replace all screws if they are in good condition. You will only have to do this
when the screws are damaged. This is important to ensure that the blades do not fall off and
to balance the blade disc. Failure to replace damaged screws with new ones could result in
serious injury.
- Blades should be changed regularly (especially if the mower is programmed to run every
day). Always check the blades for chips or damage and, if so, replace them with new ones.
When the blades are not sharp or are worn, replace them. Use the replacement blades
provided.
- Before changing the blades, turn off the mower and put on protective gloves.
NOTE: after screwing the blades to the disc, make sure that they can rotate properly.
Mower storage in winter
The lifespan of the mower will be longer if you store it during the winter. For this reason, we
recommend that you store it in a shed or garage during the winter season.
But, before doing so, we recommend the following:
1. Clean the mower thoroughly.
2. Fully charge the battery and remove it from the mower.
3. Disconnect it.
4. To maximise the life of the battery, fully charge the battery and remove it from the mower.
WARNING: prevent the bottom of the mower from coming into contact with water. If the mower
is to be stored outdoors, do not turn it upside down.
124
CONGA GRASSHOPPER 300