cecotec CONGA GRASSHOPPER 300 Manual De Instrucciones página 127

E9
BP
E11
E12
E13
E14
The mower is stuck
The battery protection
system has been
activated
The mower does not
receive a signal from
the boundary wire
Battery problem
Charging problem
The working area is too
large
1. Position the mower in an area where
there are no obstacles.
2. If the error still appears, contact the
official Cecotec Technical Support
Service.
1. Check the battery temperature. If it is
too high, wait until it cools down. If it
is too low, wait until the temperature
rises above 5 °C.
2. If the error still appears on the
display, contact the official Cecotec
Technical Support Service.
1. When the mower is inside the
working area, check the colour of
the indicator light on the charging
station. If it is red, it means that
the boundary wire is not properly
connected to the charging station.
2. If the cable is properly connected,
but the indicator light is still red,
check that the cable is not broken.
3. If the error still appears on the
display, contact the official Cecotec
Technical Support Service.
Contact the official Cecotec Technical
Support Service to change the battery.
1. Check that the charging head is
clean.
2. If the error still appears on the
display, contact the official Cecotec
Technical Support Service.
1. Reduce the size of the working
area. Follow the instructions on this
manual.
2. If the error still appears on the
display, contact the official Cecotec
Technical Support Service.
CONGA GRASSHOPPER 300
ENGLISH
127