Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged .
♦
If the red and green control LEDs
flash, this means that the battery pack
defective .
♦
Push the battery pack
♦
Switch off the charger
between successive charging sessions .
Also disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack
the appliance .
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
the status of the battery (see also main diagram) .
The status will be shown on the battery display
LED
as follows:
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PSSA 20-Li A1
flashes, this means
has overheated and
both
is
into the appliance .
for at least 15 minutes
to click into place in
and remove the
to check
Fitting/changing the saw blade
WARNING!
►
Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury .
♦
Turn the quick-release chuck
stop and hold it in this position .
♦
Push the required saw blade
quick-release chuck
CAUTION!
►
The teeth of the saw blade
downwards!
♦
Let go of the quick-release chuck
returns to its initial position . The saw blade
is now locked .
as far as the
into the
as far as the stop .
must point
so that it
GB │ IE
│
21
■
Publicidad
