Toyotomi FF-95 Instrucciones De Uso página 7

3) Setting of a day of the week
"dAy" sign is shown on the display and day of the week will blink.
Press the " MIN." button or the " HOUR" button to set a day of the week. A day of the week will blink.
(Initial setting is "SUN".) The other days of the week will go off. Select a day of the week by using the " MIN."
or the " HOUR" button. When pressing the " MIN." button, the sign will change as follows.
"SUN" "MON"
When pressing the " MIN." button at the position of "SAT", you can hear a beep sound and "SAT" is not
changed any more. When pressing the " HOUR" button, the sign will change as follows.
"SAT" "FRI"
When pressing the " HOUR" button at the position of "SUN", you can hear a beep sound and "SUN" is
not changed any more.
Press the "SET" button to complete the setting of the days of the week. The current time and a day of the
week will show on the display.
NOTE: In case, ON/OFF button is pressed while the time and day is setting, the setting will not be
completed. Set the time and day again.
MANUAL OPERATION
Operation of the heater is under the direct control of the user. Heat output will, however, be automatically adjusted
in accordance with the room temperature registered by the temperature sensor.
1. Turning Heater ON
A. Press ON/OFF button to "ON" position. The current room temperature and the set
temperature will be shown on the Display. If the room temperature is below the set
temperature then. ON lamp will start to flash and then blower motor and ignition will
start. This lamp will continue to flash during the preheating time.
B. After approx. 1.5 – 4 minutes ignition will take place. (*) After ignition, ON lamp will change
flashing to continuous.
Circulation fan will turn on after approx. 2 minutes.
NOTE: (*) Preheating depends on the room temperature.
Room temperature:
below 0˚C
0˚C - 15˚C
15˚C Over
2. Adjusting Room Temperature
A. Press " MIN." or " HOUR" button. ˚F or ˚C will start to flash.
NOTE: " MIN." or " HOUR" button will change the temperature in increment of 1°C
(2°F).
B. Press " MIN." for up and " HOUR" for down. Room temperature can be set from 10˚C
(50˚F) to 32˚C (90˚F). (Initial setting : 13˚C (56˚F))
C. When room temperature reaches the selected setting, heater will automatically shift to
"MED" or "LOW" burning mode to maintain the desired temperature.
When room temperature exceeds the selected setting by approx. 2˚C (4˚F), the heater
will automatically shut off. As room temperature drops, the heater will automatically re-
start to maintain the desired temperature.
POWER SAVER OPERATION
The Power Saver mode reduces the frequency of ignition actions, to save electric
consumption. Press the POWER SAVER (CHILD LOCK) button "ON" while in operation to
start the operation of the "POWER SAVER". "POWER SAVER" sign will be shown on the
display.
When the room temperature exceeds the selected setting by approximately 6˚C (12˚F), the
heater will automatically shut off. As the room temperature becomes lower than the selected
setting, the heater will automatically re-start to maintain the desired temperature.
"TUE" "WED" "THU"
"THU" "WED" "TUE"
OPERATION
Approx. 4 minutes
Approx. 2 minutes
Approx. 1.5 minutes
"FRI" "SAT"
"MON" "SUN"
ENGLISH
GB
6