Matrix CXC Instrucciones De Montaje página 122

MAINTENANCE
1. Any and all part removal or replacement must be
performed by a qualified service technician.
2. DO NOT use any equipment that is damaged and or has worn or broken parts.
Use only replacement parts supplied by your country's local MATRIX dealer.
3. MAINTAIN LABELS AND NAMEPLATES: Do not remove labels for
any reason. They contain important information. If unreadable or
missing, contact your MATRIX dealer for a replacement.
4. MAINTAIN ALL EQUIPMENT: Preventative maintenance is the key to
smooth operating equipment as well as keeping your liability to a
minimum. Equipment needs to be inspected at regular intervals.
5. Ensure that any person(s) making adjustments or performing maintenance or
repair of any kind is qualified to do so. MATRIX dealers will provide service
and maintenance training at our corporate facility upon request.
B
A
РУССКИЙ
C
122
MAINTENANCE SCHEDULE
ACTION
Clean the indoor cycle using soft cloths or paper towels or other
Matrix approved solution (cleaning agents should be alcohol
and ammonia free). Disinfect the saddle and handlebars and
wipe off all bodily residues.
Make sure that the indoor cycle is level and does not rock.
Clean entire machine using water and a mild soap or other
Matrix approved solution (cleaning agents should be alcohol
and ammonia free).
Clean all exterior parts, the steel frame, front and rear
stabilizers, seat and handlebars.
Test the emergency brake to make sure it is functioning
properly. To do this, press down the red emergency brake
lever while pedaling. When functioning properly, it should
immediately slow down the flywheel until it comes to a
complete stop.
Lubricate the saddle post (A). To do this, raise the saddle post to
the MAX position, spray with maintenance spray and rub down
the entire exterior surfaces with a soft cloth. Clean the saddle
slide (B) with a soft cloth and if necessary apply a small amount
of lithium/silicone grease.
Clean the handlebar slide (C) with a soft cloth and if necessary
apply a small amount of lithium/silicone grease.
Inspect all assembly bolts and pedals on the machine for proper
tightness.
5 mm
FREQUENCY
AFTER EACH USE
DAILY
WEEKLY
BI-WEEKLY
BI-WEEKLY
BI-WEEKLY
MONTHLY
MONTHLY