Medion MD 37763 Manual De Instrucciones página 110

Fig. 4 – Appliance dimensions
 Only connect the mains plug (24) to a properly in-
stalled and freely accessible socket if the water supply
and outlet have been connected correctly (see next
section).
7.2. Water connection
NOTICE!
Damage to the appliance!
If the appliance is connected improperly, there is a risk of
damage to the appliance.
 The hose must be free of kinks and connected careful-
ly.
 If the water pipes are new or have not been used for
a long time, run the water to ensure that the water is
clear and free of impurities. If this precaution is not tak-
en, there is a risk of the water inlet becoming blocked
and the appliance being damaged.
 If the appliance is to replace an old appliance, never
use old hose sets for the connection. Connect the ap-
pliance with the new hose sets provided.
 Connect the appliance to a drinking water pipe up to
max. 60°C.
 Only use the accessories supplied or accessories which
are described as suitable in this user manual.
When connecting to the drinking water, ensure that the
appliance is connected to a safety device to stop the
drinking water becoming contaminated by backflow
(in accordance with DIN EN 1717). We recommend hiring
a qualified specialist to perform the installation work,
including the water and electrical connections, and any
repair work.
If the hose supplied does not fit your tap, you can buy
adapters from your plumbing supply store.
108
4 2 0
435
 Connect the water supply hose (25) to a cold water tap
You can connect the supply hose to a hot water tap if the
water temperature does not exceed 60°C. This reduces
wash time by about 15 minutes.
 Screw the hose connection hand tight.
The water hose is designed for a water pressure of approx.
10 bar. We recommend turning off the water supply after
use, especially if your house connection does not have a
pressure reducer.
7.3. Filling with water manually
Before adding water, press the
dishwasher.
As an alternative to using the water supply via a water tap,
you can also fill up the appliance with water manually (see
Fig. 6).
It is always necessary to fill up the appliance as soon as
the warning light
sound.
 Fill the measuring container (7) with clean tap water.
 Remove the water tank cover (12).
 Fill the water tank with water (min./max. 5 litres). Take
 Put on the water tank cover.
Fig. 5 – Connecting the water hose
with a 3/4" thread (see Fig. 5).
Fig. 6 – Filling with water
lights up. Acoustic signals will
care to pour the water into the water tank opening
slowly and carefully to avoid splashing.
button to switch on the