Publicidad
Idiomas disponibles
Idiomas disponibles
10.3. Cleaning the appliance
NOTICE!
Possibility of damage to the appliance!
Damage to the appliance is possible if incorrect detergent
is used.
Do not use harsh detergents or scouring agents or
sharp objects to clean the appliance. Scraping materi-
als such as steel wool or sponges with a scrubbing side
are not suitable either.
Clean the outside of the appliance with mild detergent
using a damp cloth.
NOTICE!
Possibility of damage to the appliance!
Risk of damage to the appliance due to moisture in the
appliance.
Clean the appliance door with a slightly damp cloth.
Make sure that no moisture penetrates into the elec-
tronics of the door lock so as not to damage the appli-
ance.
To protect the control panel, make sure that no mois-
ture comes into contact with the electronics.
Do not use spray cleaner.
NOTICE!
Possible material damage!
Material damage is possible in the event of water leakage.
Turn off the water supply before cleaning or empty
the water tank (see "10.1. Pump water out of the water
tank" on page 117).
Fig. 25 – Removing the spray arm
Remove the spray arm (4) inside the appliance (see
Fig. 25) to clean it. Lift this slightly and remove it.
Clean the spray arm under running water and check
that the openings are not blocked. Reinstall it again
afterwards.
In case of grease deposits, run the intensive program
without a load to clean the interior.
118
To remove stains or soiling from the interior surfaces,
use water and a cloth dampened with a little vinegar
or detergent suitable for a dishwasher.
11. Antifreeze protection
When operating in cold environments, e.g. during the
winter months, follow these instructions after each wash
cycle to prevent freezing:
Pull the mains plug (24) out of the mains socket.
Turn off the water supply, if necessary, and disconnect
the water hose from the water inlet valve.
Allow the water to drain out of the hose and valve (e.g.
into a bucket).
Reconnect the hose to the water inlet valve.
Remove the filter system on the base of the appliance
and collect the remaining water from the appliance
base using a rag or sponge.
Contact customer services or a similarly qualified person if
the appliance does not function due to freezing.
12. Longer periods without use
WARNING
Risk of explosion!
Under certain conditions, hydrogen gas may be produced
in a hot water system that has not been used for two
weeks or more. HYDROGEN GAS IS HIGHLY EXPLOSIVE!
If you have not used the dishwasher for an extended
period of time, open all hot water taps and allow the
water to flow for several minutes before using the
dishwasher. This releases pent up hydrogen gas from
the system.
As hydrogen gas can ignite, avoid naked flames during
this time and do not smoke.
Perform a wash cycle without load.
Pull the mains plug out of the socket.
Turn off the water supply before cleaning or empty
the water tank (see "10.1. Pump water out of the water
tank" on page 117).
Leave the appliance door open slightly to prevent po-
tential odours from forming and preserve the seal.
13. Moving the appliance
Always transport the appliance vertically, wherever possi-
ble. If necessary, it is also possible to transport the appli-
ance on its back.
Publicidad
