Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
!
WARNING
NOTE
NOTE
Remove for a
pressure
range of 0.3
to 1 bar
Assembly
Hazard due to defective assembly!
Assemble the Testomat
from drips and splashes of water, dust and aggressive substances
– e.g. in a switching cabinet or on a suitable wall.
Notes for problem-free operating procedures
Assemble the Testomat
mechanical stresses.
Assemble the Testomat
tion.
Assembling the Testomat
Requirements for the installation site
Select an installation site at which the length of the water inlet hose
can be minimized (max. 5 m)
Leave sufficient room on the left side of the device to open the
door.
Drill the mounting holes as specified in the accompanying sketch-
es.
Secure the device with three screws in a suitable place in the
switching cabinet or on the wall.
Use of the Testomat
sure range of 0.3 to 1 bar
Before assembling please check whether adaptation to a lower work-
ing pressure is required. When delivered, the device is equipped for a
pressure range of 1 to 8 bar. To operate the device within a pressure
range of 0.3 to 1 bar, the flow governor core
(e.g. when using a
locking pin
troller plug
the flow governor core
pin.
At pressures under 0.3 bar or when sucking out of a tank, our
puClip booster pump
®
EVO TH device in a location shielded
®
EVO TH device vertically and without
®
EVO TH device in a location free of vibra-
®
EVO TH within a pres-
type R mini
irrigator). For this purpose, take the
from the controller/filter housing
on the metal brackets out of the drill hole. Then remove
and re-insert the controller plug and locking
can be used.
Assembly
®
EVO TH
should be removed
. Then pull the con-
Me-
15
Publicidad
Tabla de contenido
