Testomat EVO TH Serie Manual De Instrucciones página 59

English
Deutsch
Français
Nederlands
Espanol
Türkçe
中文
Czech
Revert to factory
default basic setting
To retrieve the factory
default basic pro-
gramming, the device
should be switched on
while pressing and
holding the buttons
OK and Manual.
CAUTION! The most
recent programming
will be lost! All Data
from SD card will be
deleted!
Language (9)
*
Select the desired language for the indicator. The number of installed
languages may vary.
Diagnosis (10)
The diagnosis menu allows you to perform an automatic comparison
for the amplifier of the receiver diode and the LEDs. You can also
switch and reset EV, AV and all outputs as well as test the current
loop.
The "Current output" point allows the current loop to be tested. The
"OK" button allows switching between minimum and maximum cur-
rent. At 0-20 mA, the variation is between 00mA and 20mA!
Operating time (12)
After replacing a dosing pump or mounting the measuring chamber,
you can reset the current operating time with
Error history (13)
Faults are recorded in the error history and stored if the incident is
programmed as an alarm or message. If for example the lack of an
indicator is not programmed to trigger an alarm/message, this is also
not registered in the error history. Up to 20 error messages are rec-
orded. The information stored in each case includes the point in time
(day, month, year and time) and the type of error.
Changing device type (14)
Under certain circumstances, this special function can be used to
programme the firmware of another device type into this device.
Please contact our support team for more information.
Basic programming
This menu option is reached after confirming the "M" button (Menu).
Here you can implement the basic programming of the device and
call up various functions for service purposes.
In basic programming, the following abbreviations are used in the
corresponding menu options:
s = seconds; m = minutes; h = hours; T = days; l = liters
Service menu
Reset
to 0 hours.
59