Water Drain; Connect Mains And Devices - Testomat EVO TH Serie Manual De Instrucciones

Dispositivo automático de análisis en línea para dureza total residual (dureza del agua)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

!
WARNING
NOTE

Water drain

The water is conveyed through the measuring chamber via an open
funnel
and the drain hose installed on the same and into the duct.
Remove the supplied funnel
the recess of the housing designated for that purpose.
Connect the funnel of the Testomat
(internal diameter 12 mm/14 mm)
Lay this hose free of back pressure and without the siphon effect
to the drain

Connect mains and devices

Risk of injury from assembly when voltage present!
Unless you disconnect the power supply before commencing assem-
bly, you risk injury, destruction of the product or damage to system
components.
Disconnect all power to the relevant system component before
assembling the Testomat
When connecting, use only verified cables with sufficient
cross-section.
Disconnecting device for the power supply
The unit has no power switch!
®
Fit the Testomat
EVO TH with a switch as a disconnecting device
for the power supply. Use an appliance switch or a circuit breaker
that meets the requirements of IEC 608947-1 and IEC 60947-3.
The switch must be within easy reach of the user of the Testomat
EVO TH and clearly marked as a disconnecting device for the Tes-
®
tomat
EVO TH.
For disconnection, you can also provide a three-pin plug near the
device, which is clearly marked as a disconnecting device for the
Testomat
®
EVO TH CAL.
Danger of damage due to electromagnetic fields!
If you assemble the Testomat
bles parallel to mains cables or in the vicinity of strong electromag-
netic fields, the device may be damaged or the measurement dis-
rupted.
Keep the connecting cables as short as possible
Lay the connecting cables and mains cables separately.
Connect the device with the protective conductor (at 230/100-240
VAC).
Keep interference voltages away from the Testomat
device – e.g. by using a mains filter.
Shield the device from strong electromagnetic fields.
and accommodate it underneath, in
®
EVO TH with a drain hose
®
EVO TH device.
®
EVO TH device or connecting ca-
Assembly
line
®
®
EVO TH
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Evo th 2005Evo th 2025Evo th 2100Evo th 2250

Tabla de contenido