Self Diagnosis - Valeo beep&park Manual De Instrucciones

No reset
necessary

Self diagnosis

Valeo beep&park system is equipped with a
®
self-diagnosis of sensors :
1. When the reverse gear is selected, the system
automatically tests the 4 rear sensors�
2. If all of the sensors are working, the system beeps
once�
3. If there is a problem with any of the sensors, the
system beeps 3 times�
4. The position and number of faulty sensors is
displayed on the screen� E1 means that 1 sensor is
not working properly, E2 : 2 sensors, E3 : 3 sensors,
E4 : 4 sensors� Screen flashing allows defect
sensor identification.
5. Check that sensors are properly fitted.
6. In case of crash, you can replace the concerned
sensor by one available in the Valeo spare parts offer
(www�smileyouaredriving�com)�
Troubleshooting
Once reverse gear is selected, a sound signal is triggered
1
when there is no obstacle behind the vehicle:
1. Check that requested height of sensors fitted on the bumper
from the floor is respected (between 45 and 60 cm).
2. Check that requested angle of sensors fitted on the bumper
is respected� If necessary, use the angle correction rings for
the installation�
3. Check that requested distance between sensors on the
bumper is respected (< or = 45 cm)�
4. Check that the sensor is not installed upside-down�
5. Unplug one sensor at a time to identify the cause of the
anomaly�
Once reverse gear is selected, an obstacle behind the
2
vehicle is not detected by the system:
1. Check that requested height of sensors fitted on the bumper
from the floor is respected (between 45 and 60 cm).
5