Valeo beep&park Manual De Instrucciones página 6

2. Check that requested angle of sensors fitted on the bumper
is respected� If necessary, use the angle correction rings for
the installation�
3. Check that requested distance between sensors on the
bumper is respected (< or = 45 cm)�
4. Check that the sensor is not installed upside-down�
5. Unplug one sensor at a time to identify the cause of the
anomaly�
3
The display does not power on after installation:
1. Check that the power supply wire is connected correctly�
2. Check that the ignition is turned to ACC ON, and that the
reverse gear is selected�
3. Check that all wire connections are correct�
4. Check that the display is not damaged�
4
The display powers on when reverse gear is not selected:
1. Check that the power wire of ECU is connected to the
reverse light wire�
The system indicates a defective sensor (the buzzer
5
beeps 3 times):
1. Check whether the sensor surface is clean�
2. Check whether the sensor wires are plugged in the ECU
properly�
3.
Check whether the sensor wires are damaged or not�
4. Check that the sensor is not damaged�
6
The object position does not correspond to the
6
correct indicator on the display:
1. Check that the sensor cables are connected to the
control unit (ECU) in the correct order (markers
ABCD)�
7
Volume of the audible alert is too low:
1. Adjust the volume to a higher level�
If the problem persists, please follow these steps:
1. Contact the dealer where you purchased the product�
2. Replace the product ECU and recheck the system�
3. Test the sensors with certified ECU.
4. Plug certified sensor into the ECU and recheck.
51