How To Use The Remote Control - Num'axes CANICOM 200 FIRST Manual De Instrucciones

CODING PROCEDURE
To code, the remote control must be ready for use (battery in place).
1. Receiver collar in position « deactivated » (indicator light off): approach the red mark located on
the remote control until coming in contact on red mark located on the receiver collar for 6 seconds.
The indicator on the collar lights in fixed green, then flashes in red.
2. Move the remote control away from the receiver collar.
3. Press the beeper button
synchronized with your remote control.
 Reprogram a receiver collar
Receiver can be re-coded indefinitely, either with the same remote control, or with a new remote control
from the CANICOM range.
Ref. § Coding procedure.

How to use the remote control

The CANICOM 200 FIRST remote control is designed to operate with 1 receiver collar.
button: beeper

If you press the « Beeper » button
this function: the beeper will continue to sound for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog. With the beeper you can:
- send a sound to your dog when he is disobedient,
- draw his attention,...
It's very important to always use the beeper in the same way in order not to disturb your dog.
 1 to 5 buttons: continuous stimulations
Button 1: lowest stimulation / Button 5: strongest stimulation
Press the button 1, 2, 3, 4 or 5 to send a warning to your dog using stimulations transmitted by the two
contact points located on the receiver collar, the warning will last for as long as the button is pressed but
limited to 8 seconds maximum.
CANICOM_200_First_indice_K 2017.indd 20
Gb - 20
of the remote control. A beep sound is emitted, the collar is then
the receiver collar will emit sound signals. There is no time limit for
17/05/2017 11:54