Publicidad
POSITIONING THE WAVESPRING FEEDER ARM
1
3
5
Page 14
2
4
GB
All self tailing models up to size 65
1. Unscrew the top cap.
2. Lift off the feeder arm.
3. Rotate the stripper ring to the required position.
4. Replace the feeder arm in the correct position to suit
the stowage of the loose sheet (see note).
5. Check the condition of the 'O' ring in the top cap.
Replace if necessary. Lubricate with a light smear of
Lewmar winch grease and replace the top cap.
Note: When replacing the feeder arm, ensure the stripper
ring is correctly located within the groove on the back of
the feeder arm.
Publicidad
