Mounting The Camera - Waeco PerfectView LCD250 Instrucciones De Montaje

PerfectView LCD250
Hot air blower (11)
Crimping tool (12)
Soldering iron (optional) (13)
Solder (optional) (14)
Cable bushing sleeves (optional)
Depending on the individual installation requirements you may require bolts, nuts, wash-
ers, self-tapping screws and cable binders other than those including in the scope of de-
livery for attaching the camera and monitor.
7.2

Mounting the camera

Note
I
If installing the camera alters the vehicle height or length specified in the vehicle
documents, your vehicle must be inspected by the appropriate authorities.
Make sure that you are in possession of documents verifying that your vehicle
has passed this inspection.
Caution!
a
Select a location for the camera and attach it so securely that it cannot under any
circumstances fall off and injure bystanders (e.g. by being knocked off by
branches brushing over the roof of the vehicle).
Observe the following installation instructions:
To provide a suitable viewing angle, the camera must be attached at a height of at least
2 m.
Ensure that you have a firm place from which to work when mounting the camera.
Ensure that the installation location of the camera is sufficiently firm (e.g. to prevent the
camera from being knocked down by branches that may brush over the roof of the ve-
hicle).
Mount the camera horizontally and in the middle of the rear of the vehicle (fig. b,
page 7).
The most secure type of attachment is with screws fitted through the body. Please ob-
serve the following instructions:
– There must be sufficient space for the mounting procedure behind the chosen in-
stallation location.
– Suitable measures must be taken to prevent water penetrating through any holes
made (e.g. by using screws and sealant and/or spraying the outer attachment parts
with a sealant).
– The location on the body where you wish to attach the camera must be rigid enough
to allow the camera to be tightly fastened.
Mounting the camera and monitor
39